Two authoring slips in the valve x actuator composition:
- The diaphragm actuator's stem stopped at y=4 while the dome's flat base
sat at y=6, so the canonical control-valve symbol (PID_VALVE_*_DIAPHRAGM,
9 catalogue entries) shipped with its dome floating 2 mm above the stem.
- Actuators were placed at a fixed y=4 regardless of the body, so on the
needle body (top 5.6) the piston/motor/solenoid glyphs were drawn over
the knob and the hand bar across the needle's stem; the stem line(0,0,0,4)
also duplicated the needle's own axial line (and the butterfly disc).
Placement is now body-relative: `_body` reports `axis_top` (where its own
geometry on x=0 ends) and the stem runs from there to the glyph base at
`body_top + STEM_CLEARANCE`; the diaphragm dome's base is the stem top
(base + DIAPHRAGM_YOKE), and the FAIL attribute follows the glyph base.
The reference 8x4 bodies keep their published numbers (globe+diaphragm
signal at y=9.0, bbox top 9.0).
Tests: per-combination check that the stem starts at the body's derived
axis top, the glyph's lowest edge equals the stem top, the glyph clears
the body, and the signal port is the topmost edge; plus a catalogue-wide
no-duplicate-primitives gate. 33 combinations fail on the old geometry.
The plan's Step 3 snippet is synced with the fixed module.
Co-Authored-By: Claude Opus 5 (1M context) <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01FKFStjEFzpGyLq5bMpWxTd
